3BSE013177R1模擬量輸入輸出模塊,3BSE013177R1培訓(xùn)教程
在基座上安裝輸入/輸出模塊
1、安裝新模塊前，拆除模塊所在位置的電纜槽敲孔
蓋住端子板連接電纜?？墒褂勉Q子或
從膜殼內(nèi)部壓出。
要安裝輸入/輸出模塊，請(qǐng)定位模塊，使模塊外殼中的電纜槽
連接電纜上方。3、用力向下按壓模塊。
4、如果感覺到阻力，請(qǐng)拆下模塊并檢查鍵控（如果使用了鍵控）。而且
確保連接電纜正確位于電纜槽中。
將輸入/輸出模塊放置到基座上后，擰緊其螺栓以將其固定。最大限度
建議扭矩為9英寸/磅。3BSE013177R1模擬量輸入輸出模塊
Installing an I/O Module on the Base
1. Before installing a new module, remove the cable slot knockout(s) wherever the module would
cover the terminal board connecting cables. The knockout can be removed with pliers, or by
pressing out from inside the module housing.
2. To install an I/O module, position the module so that the cable slot in the module housing is
over the connecting cable.3. Press the module down firmly.
4. If you feel resistance, remove the module and check the keying (if keying has been used). Also
be sure the connecting cable is in the cable slot properly.
5. After placing an I/O module onto the base, tighten its bolts to secure it. Maximum
recommended torque is 9 in/lbs.
