Triconex AI3351庫存?zhèn)浼?/h1>線路電抗器
編號：DC Amps AC Line Amps Hp IP00（開放式）線路電抗器線路電抗器AC輸入接觸器非再生再生類別。數(shù)量kW（Hp）類別。 此驅動額定值無交流輸入接觸器-必須在當?shù)夭少彙ｒ寗覥at。編號：DC Amps AC Line Amps Hp IP00（開放式）線路電抗器線路電抗器AC輸入接觸器非再生再生類別 隔離變壓器-IP32，NEMA/UL 3R型獨立，4…6%標稱阻抗隔離變壓器可用于具有特定類型交流電源配置或因交流線路干擾需要驅動保護的裝置。三相初級三相次級kVA kW（Hp）電壓230V次級460V次級575V次級類別號。
端子適配器套件
架D端子適配器套件以下機架D驅動器需要列出的端子適配器套件，以滿足UL安裝要求。三相一次三相二次kVA kW（Hp）電壓230V二次460V二次575V二次分類號 不屬于Rockwell Automation的商標是其各自公司的財產。出版物2364F-5.13 1999年6月更換套件說明RGU? 隔離板更換內容本文檔介紹了如何拆卸和更換再生直流母線電源裝置（RGU）中的隔離板和負載電阻器。此工具包包含的內容使用下表，驗證您已收到工具包中的相應項目。如果您收到了隔離板套件：如果您收到負載電阻器套件：注意：請參閱表a以驗證您是否收到了適當?shù)呢撦d電阻器套件。
Line reactor
No.: DC Amps AC Line Amps Hp IP00 (open type) Line reactor Line reactor AC input contactor Non regenerative regeneration category. Quantity kW (Hp) category. This drive rating has no AC input contactor - must be purchased locally. Drive Cat. No.: DC Amps AC Line Amps Hp IP00 (open type) Line reactor Line reactor AC input contactor Non regenerative regenerative type isolation transformer IP32, NEMA/UL 3R type independent, 4... 6% nominal impedance isolation transformer can be used for devices with specific type of AC power supply configuration or requiring drive protection due to AC line interference. Three phase primary three-phase secondary kVA kW (Hp) voltage 230V secondary 460V secondary 575V secondary category number.
KIT-TERMINAL ADAPTER
Rack D Terminal Adapter Kit The following rack D drives require the listed terminal adapter kit to meet UL installation requirements. The three-phase primary three-phase secondary kVA kW (Hp) voltage 230V secondary 460V secondary 575V secondary classification number does not belong to the trademark of Rockwell Automation and is the property of their respective companies. Publication 2364F-5.13 June 1999 Replacement Kit Description RGU ? Isolation board replacement content This document describes how to remove and replace the isolation board and load resistor in the regenerative DC bus power supply unit (RGU). Use the following table to verify that you have received the corresponding items in the toolkit. If you have received the isolation board kit: If you have received the load resistor kit: Note: Refer to Table a to verify that you have received the appropriate load resistor kit.
