VMIVME-7750-734001 DCS工控模塊備件
遵循以下步驟
如果需要使用信道代替遵循以下步驟：確保您的軟件將永久設置為高電平這將永久禁用接收器焊接一個分流電阻器代替（焊料滴就可以了 通過收發器將總線（包括握手信號控制和命令）連接到陽連接器圖 如上所述與端口共享連接到收發器連接到點連接器該設計包括用于總線終端電阻器選擇的可選跳線圖 顯示接口帶有透射式模塊和觸摸面板其集成驅動為顯示面積為英寸對角線測量原始分辨率為 點
模塊模塊通過信號復位
如上所述該與端口和按鈕共享芯片選擇信號連接到；跳線可以斷開它使得該線可用于其他定制用途通過與通信其中位并行“樣”協議數據總線必須由軟件實現 評估套件硬件開發板用戶指南––年月日圖塊背光控制背光由四個平行排列的集成白色芯片組成它們由電荷泵驅動由通過單個線接口控制；歐姆電阻器串聯安裝在該線路上這允許將其用于其他定制用途在這種情況下上拉電阻器默認保持電荷泵永久啟用在陽極驅動線上歐姆電阻器串聯實現用于可選的電流限制
Follow these steps
If you need to use a channel instead, follow these steps: Make sure your software will be permanently set to high level, which will permanently disable the receiver from welding a shunt resistor instead (solder drops can be used to transfer the bus through the transceiver (including handshake signal control and command) Connect to the male connector diagram Share with the port as described above Connect to the transceiver Connect to the point connector This design includes an optional jumper diagram for bus terminal resistor selection Display interface with transmissive module and touch panel Its integrated drive is the display area is inches Diagonal measurement original resolution is points
Module reset by signal
As described above, the port and button sharing chip selection signal are connected to the; The jumper can be disconnected so that the wire can be used for other customized purposes. The "sample" protocol data bus must be implemented by software. The evaluation kit hardware development board user's guide – – The figure block backlight control backlight is composed of four integrated white chips arranged in parallel. They are driven by the charge pump and controlled by a single line interface; The ohmic resistor is installed in series on the line, which allows it to be used for other customized purposes. In this case, the pull-up resistor keeps the charge pump permanently enabled by default. The ohmic resistor is implemented in series on the anode drive line for optional current limiting
