VMIVME-5530S332-000132-C工控DCS系統備件
此處所述的產品
本文件受上規定的具體免責聲明的約束。溝道 標記代碼：特征?功率%測試材料分類：有關符合性的定義請訪問。應用便攜式設備用轉換器負載開關注意事項包裝限制表面安裝在 板上 穩態條件下的最大溫度為產品概述 最大值(? 開時最大(? 典型值。 配置單頂視圖 溝道 訂購信息包無鉛和無鹵素絕對最大額定值除非另有說明參數限制單元漏極源極電壓 柵極源極電壓連續漏極電流 脈沖漏極電流 連續源極漏極二極管電流 最大功耗
存儲溫度范圍
工作結和存儲溫度范圍至釬焊建議峰值溫度 熱阻額定值參數符號典型最大機組最大結至環境溫度 ? 最大接腳排水穩態 。 版本。 年月日文件編號：有關技術問題請聯系：@本文件如有更改恕不另行通知。此處所述的產品和本文件受上規定的具體免責聲明的約束。注釋脈沖測試；脈沖寬度? μ占空比? %由設計保證不進行生產測試。超過絕對最大額定值中列出的應力可能會對設備造成永久性損壞。這些僅為應力額定值不暗示設備在這些任何其他條件下的功能操作超出規范操作章節中的規定。
Products described here
This document is subject to the specific disclaimers set forth above. Channel marker codes: features ? Power% Test Material Classification: For a definition of compliance, visit. Notes on the application of converter load switch for portable equipment Packaging limits the maximum temperature of the surface mounted on the board under steady state conditions to the maximum value of the product overview (▼ Typical. Configuration Single Top View Channel Ordering Information Package Lead Free and Halogen Free Absolute Maximum Rating Unless otherwise specified Parameters Limit Unit Drain Source Voltage Grid Source Voltage Continuous Drain Current Pulse Drain Current Continuous Source Drain Diode Current Maximum Power Consumption
Storage temperature range
Working junction and storage temperature range to recommended peak temperature for brazing Thermal resistance rating parameter symbol Typical maximum unit Maximum junction to ambient temperature ≤ Maximum pin drain steady state. edition. Document No.: For technical problems, please contact: @ This document is subject to change without notice. The products described herein and this document are subject to the specific disclaimers set forth above. Note Pulse test; Pulse width ≤ μ Duty cycle ≤% is guaranteed by the design not to conduct production test. Exceeding the stresses listed in the absolute maximum ratings may cause permanent damage to the equipment. These are stress ratings only and do not imply that the functional operation of the equipment under any of these other conditions exceeds those specified in the operating section of the specification.
