MVME177P-55SE電源模塊
必須根據本部分第598.1（l）節批準使用等效技術。（e） 防止泵和閥門泄漏。在1999年12月22日之前，所有者或操作員必須使用以下一種或多種方法防止控制液體危險物質的所有泵和閥門溢出和泄漏：（1）安裝無密封泵和閥門、故障安全雙密封泵和閥或同等技術；（2） 實施泵和閥門維護和維修計劃。檢查頻率和維護和維修范圍必須基于至少五年的實際操作和服務記錄、制造商建議或類似操作記錄。必須在防泄漏報告中確定計劃依據、檢查頻率以及維護和維修范圍；或（3）將泵和閥門安裝在集水池內，如集油盤、墊或二級密封系統。集水盆地的設計和建造必須使儲存物質的滲透率小于等于1 x 10-6 cm/sec，并與儲存的有害物質兼容。如果使用了集水池，則必須每天檢查其是否有液體積聚，并且其容量足以容納可能積聚在集水池中的所有溢出物。（f） 升級現有的固體存儲。
在環境溫度下為水溶性固體的危險物質必須儲存在防止雨水進入的容器中，或儲存在由建筑物或類似圍護結構保護的防止雨水進入?yún)^(qū)域中。容器（包括地板）的設計和構造必須使其對儲存的物質的滲透率小于等于1 x 10-6 cm/sec。（g） 升級集裝箱存儲區域。（1） 在1999年12月22日之前，容器必須滿足以下要求：6 NYCRR第598部分–2015年10月11日第11頁，共35頁598.5（g）（i）容器中儲存的不兼容物質不得相互靠近。至少，它們必須相隔30英尺；耐火等級不低于兩小時的防火墻；分開的獨立堤壩；或防止意外混合并降低事故、泄漏或泄漏可能性的其他等效系統；（ii）必須為裝有可能與水反應產生熱量、導致容器內壓力積聚或?qū)е禄馂?zāi)、爆炸或其他不良反應的材料的容器提供圍封，如倉庫或避風塘。外殼必須保護容器不暴露于水，設計為能夠抵御風暴，并固定在地面上；（iii）容器必須位于一個區域，該區域具有不透水的地板和足夠高的周邊路緣石或斜坡，以容納最大容器內容物的110%或容納區域內互連容器可能溢出的總體積，以較大者為準。
The use of equivalent technology must be approved in accordance with section 598.1 (l) of this part. (e) Prevent pump and valve leakage. Before December 22, 1999, the owner or operator must use one or more of the following methods to prevent overflow and leakage of all pumps and valves controlling liquid hazardous substances: (1) install unsealed pumps and valves, fail safe double seal pumps and valves or equivalent technology; (2) Implement pump and valve maintenance and repair plan. The inspection frequency and maintenance and repair scope must be based on at least five years of actual operation and service records, manufacturer's recommendations or similar operation records. The plan basis, inspection frequency and maintenance and repair scope must be determined in the leakage prevention report; Or (3) Install the pump and valve in the sump, such as oil pan, gasket or secondary sealing system. Catchment basins must be designed and constructed so that the permeability of the stored material is less than or equal to 1 x 10-6 cm/sec and compatible with the stored hazardous material. If catch basins are used, they must be checked daily for fluid accumulation and have sufficient capacity to contain any spillage that may accumulate in the catch basins. (f) Upgrade existing solid storage.
Hazardous substances that are water-soluble solids at ambient temperature must be stored in containers that prevent rainwater from entering, or in areas protected by buildings or similar enclosures that prevent rainwater from entering. The container (including the floor) must be designed and constructed so that its permeability to the stored material is less than or equal to 1 x 10-6 cm/sec. (g) Upgrade container storage area. (1) By December 22, 1999, containers must meet the following requirements: 6 NYCRR Part 598 – October 11, 2015 Page 11 of 35 598.5 (g) (i) Incompatible substances stored in containers must not be close to each other. At a minimum, they must be separated by 30 feet; Firewalls with a fire resistance rating of not less than two hours; Separate and independent dykes; Or other equivalent system to prevent accidental mixing and reduce the possibility of accidents, leaks or leaks; (ii) Containers containing materials that may react with water to generate heat, cause pressure buildup in the container, or cause fire, explosion, or other adverse reactions, such as warehouses or wind shelters, must be provided with enclosures. The enclosure must protect the container from water exposure, be designed to withstand storms, and be fixed to the ground; (iii) The container must be located in an area with impervious floors and surrounding kerbs or ramps high enough to accommodate 110% of the largest container contents or the total volume of interconnected containers that may spill over the containment area, whichever is greater.
