MVME167-34B模塊備件
1.2V DC下的電流消耗-5.1V DC時的電流消耗1200 mA 24V DC時的電壓消耗14 mA功耗3.5 W散熱11.9 BTUhr隔離電壓30V（連續），基本絕緣類型，RS-232至系統類型，在720V DC下測試60 s串行電纜1756-CP3或1747-CP3，控制器的直角連接器，直接到串行端口3米（9.84英尺）重約0.32千克（0.70磅）插槽寬度2，（兩個模塊都需要；每個都是一個插槽）模塊位置機箱底座任何插槽（安全伙伴必須安裝在主控制器右側的插槽中）機箱1756-A4、1756-A7、1756-A10、1756-A13、1756-A17電源標準1756-PA72、1756-PA75、1756-PB72、，1756-PB75導線類別使用此導線類別信息規劃導線布線，如系統級安裝手冊所述。參見工業自動化布線和接地指南出版物1770-4.1.2-RS-232端口北美溫度代碼T4A外殼類型額定值無（開放式）羅克韋爾自動化出版物1756-TD001G-EN-P-2013年1月17 1756 ControlLogix控制器表19-環境規范-1756-L6xS GuardLogix控制器屬性1756-L61 1756-L62 1756-L63 1756-LSP溫度，1756-L61 1756-L62 1756-L63 1756-LSP上的運行IEC 60068-2-1（試驗A運行低溫）、IEC 60068-2-2（試驗B運行干熱）、IEC 6008-2-14（試驗N運行熱沖擊）0…60°C（32…140°F，IEC 60068-2-14（試驗N無包裝非工作熱沖擊）-40…85°C（-40…185°F）環境空氣溫度，最高60°C（140°F）相對濕度IEC 60068-2-30（試驗D未包裝濕熱）5…95%非冷凝振動IEC 60068-2-6（試驗F運行）2 g@10…500 Hz Shoc運行IEC 60068-2-27（試驗E未包裝沖擊）30 g Shoc未運行IEC 60068－227（試驗E不包裝沖擊）50 g排放CISPR 11 IEC 61000-6-4 A級ESD抗擾度IEC 61000-4-2 6 kV接觸放電8 kV空氣放電輻射射頻抗擾度IEC 61000-4-3 10Vm，1 kHz正弦波，80%AM，從80…2000 MHz 10Vm，200 Hz 50%脈沖，100%AM@900 MHz 10Vm和200 Hz 50%，100%AM，1890 MHz 3Vm，1 Hz正弦波，80%AM，從2000…2700 MHz EFTB抗擾度，IEC 61000-4-4±4 kV，5 kHz，RS-232端口浪涌瞬態抗擾度IEC 61000-4-6 10V rms，1 kHz正弦波80%AM，150 kHz…80 MHz 18羅克韋爾自動化出版物1756-TD001G-EN-P-2013年1月1756 ControlLogix控制器表20-認證-1756-L6xS GuardLogix控制器認證標記時。有關符合性聲明、證書和其他認證詳細信息，請參見產品認證鏈接：www.ab.com。1756-L61 1756-L62 1756-L63 1756-LSP c-UL-us UL認證工業控制設備，適用于美國和加拿大。參見UL文件E65584。UL列出了經美國和加拿大認證的2類D組危險場所。參見UL文件E194810。CSA CSA認證過程控制設備。參見CSA文件LR54689C。CSA認證的過程控制設備，適用于2類D組危險場所。參見CSA文件LR69960C。CE歐盟2004108EC EMC指令，符合：EN 61000-6-4；工業排放EN 61326-1；測量控制實驗室。，工業要求EN 61000-6-2；工業抗擾度EN 61131-2；可編程控制器（第8條，A區和B區）歐盟200642EC M符合：EN 60204-1；機器電氣設備EN ISO 13849-1；控制系統的安全相關部件EN 62061；安全相關控制系統的功能安全C-Tick澳大利亞無線電通信Ac符合：AS/NZS CISPR 11；工業排放FM FM認證設備，用于第2類D組危險場所KC韓國廣播和通信設備注冊，符合：無線電波交流條款第58-2條
Current draw @ 1.2V DC — Current draw @ 5.1V DC 1200 mA Current draw @ 24V DC 14 mA Power dissipation 3.5 W Thermal dissipation 11.9 BTUhr Isolation voltage 30V (continuous), Basic Insulation Type, RS-232 to system Type tested at 720V DC for 60 s Serial cables 1756-CP3 or 1747-CP3, right angle connector to controller, straight to serial por 3 m (9.84 ft) Weigh approx 0.32 kg (0.70 lb) Slot width 2, (both modules needed; each is one slot) Module location Chassis-base any slot (the safety partner must be installed in the slot to the immediate right of the primary controller) Chassis 1756-A4, 1756-A7, 1756-A10, 1756-A13, 1756-A17 Power supply standard 1756-PA72, 1756-PA75, 1756-PB72, 1756-PB75 Wire category Use this conductor category information for planning conductor routing as described in the system level installation manual. See the Industrial Automation Wiring and Grounding Guideline publication 1770-4.1. 2 - on RS-232 port North American temperature code T4A Enclosure type rating None (open-style) Rockwell Automation Publication 1756-TD001G-EN-P - January 2013 17 1756 ControlLogix Controllers Table 19 - Environmental Specifications - 1756-L6xS GuardLogix Controllers Attribute 1756-L61 1756-L62 1756-L63 1756-LSP Temperature, operating IEC 60068-2-1 (Test A Operating Cold), IEC 60068-2-2 (Test B Operating Dry Heat), IEC 60068-2-14 (Test N Operating Thermal Shock) 0…60 °C (32…140 °F) on 1756-L61 1756-L62 1756-L63 1756-LSP Temperature, storage IEC 60068-2-1 (Test A Unpackaged Nonoperating Cold), IEC 60068-2-2 (Test B Unpackaged Nonoperating Dry Heat), IEC 60068-2-14 (Test N Unpackaged Nonoperating Thermal Shock) -40…85 °C (-40…185 °F) Temperature, surrounding air, max 60 °C (140 °F) Relative humidity IEC 60068-2-30 (Test D Unpackaged Damp Heat) 5…95% noncondensing Vibration IEC 60068-2-6 (Test F Operating) 2 g @ 10…500 Hz Shoc operating IEC 60068-2-27 (Test E Unpackaged Shock) 30 g Shoc nonoperating IEC 60068-2-27 (Test E Unpackaged Shock) 50 g Emissions CISPR 11 IEC 61000-6-4 Class A ESD immunity IEC 61000-4-2 6 kV contact discharges 8 kV air discharges Radiated RF immunity IEC 61000-4-3 10Vm with 1 kHz sine-wave 80% AM from 80…2000 MHz 10Vm with 200 Hz 50% Pulse 100% AM @ 900 MHz 10Vm with 200 Hz 50% Pulse 100% AM @ 1890 MHz 3Vm with 1 kHz sine-wave 80% AM from 2000…2700 MHz EFTB immunity IEC 61000-4-4 ±4 kV at 5 kHz on RS-232 port Surge transient immunity IEC 61000-4-5 ±2 kV line-earth (CM) on RS-232 port Conducted RF immunity IEC 61000-4-6 10V rms with 1 kHz sine-wave 80% AM from 150 kHz…80 MHz 18 Rockwell Automation Publication 1756-TD001G-EN-P - January 2013 1756 ControlLogix Controllers Table 20 - Certifications - 1756-L6xS GuardLogix Controllers Certification When marked. See the Product Certification link at http:www.ab.com for Declarations of Conformity, Certificate and other certification details. 1756-L61 1756-L62 1756-L63 1756-LSP c-UL-us UL Listed Industrial Control Equipmen certified for US and Canada. See UL File E65584. UL Listed for Class Division 2 Group D Hazardous Location certified for U.S. and Canada. See UL File E194810. CSA CSA Certified Process Control Equipment. See CSA File LR54689C. CSA Certified Process Control Equipment for Class Division 2 Group D Hazardous Locations. See CSA File LR69960C. CE European Union 2004108EC EMC Directive, compliant with: EN 61000-6-4; Industrial Emissions EN 61326-1; Meas.ControlLab., Industrial Requirements EN 61000-6-2; Industrial Immunity EN 61131-2; Programmable Controllers (Clause 8, Zone A & B) European Union 200642EC M compliant with: EN 60204-1; Electrical equipment of machines EN ISO 13849-1; Safety-related parts of control systems EN 62061; Functional safety of safety-related control systems C-Tick Australian Radio communications Ac compliant with: ASNZS CISPR 11; Industrial Emissions FM FM Approved Equipment for use in Class Division 2 Group D Hazardous Locations KC Korean Registration of Broadcasting and Communication Equipmen compliant with: Article 58-2 of Radio Waves Ac Clause
