EMERSON VE4002S1T2B3離散輸出卡
如果有疑問，請咨詢系統管理員。MVME7100的控制臺設置如下：? 每個字符八位? 每個字符一個停止位? 奇偶校驗已禁用（無奇偶校驗）? 9600波特的波特率驗證是否安裝了硬件，以及連接的電源/外圍設備電纜是否適合您的系統配置。裝回機箱或系統護蓋，將機箱重新連接到交流或直流電源，然后打開設備電源。工廠安裝的Linux基于2.6.25內核的可啟動ramdisk Linux映像可在NOR閃存中使用。要啟動此映像，請使用以下MOTLOAD命令：file提供了MVME7100 Linux的簡要概述。有關使用MVME7100 Linux的內核補丁和其他信息，請聯系SMART Embedded Computing。概述本章概述了MVME71000基板的控件、LED、連接器和標頭。MVME7216E轉換模塊的連接器可在Board Layout中找到。下圖顯示了MVME7100上的組件、LED、連接器和復位開關。
If in doubt, ask your system administrator. The console settings for the MVME7100 are: ? Eight bits per character ? One stop bit per character ? Parity disabled (no parity) ? Baud rate of 9600 baud Verify that hardware is installed and the power/peripheral cables connected are appropriate for your system configuration. Replace the chassis or system cover, reconnect the chassis to the AC or DC power source, and turn the equipment power on.Factory Installed Linux A bootable ramdisk based Linux image based on the 2.6.25 kernel is available in NOR flash. To boot this image, use the following MOTLOAD commands:file provides a brief overview of MVME7100 Linux. Contact SMART Embedded Computing for kernel patches and additional information on using MVME7100 Linux.Overview This chapter summarizes the controls, LEDs, connectors, and headers for the MVME7100 baseboard. Connectors for the MVME7216E transition module can be found Board Layout The following figure shows the components, LEDs, connectors, and the reset switch on the MVME7100.
