EMERSON KJ3202X1-BA1渦流傳感器及前置器
前面板MVME7100前面板上提供以下開關、LED和連接器。每個復位/中止開關的位置見圖3-1。MVME7100有一個按鈕開關，可提供中止和復位功能。當開關按下少于3秒時，MC8641D PIC會產生一個中止中斷。如果開關保持超過3秒，則會生成板硬復位。如果MVME7100是VMEbus系統控制器，則會生成VME SYSRESET。LED下表描述了MVME71000前面板上的LED。有關LED位置，請參閱第47頁圖3-1。BFL板故障前面板紅色。此指示燈在硬復位期間點亮，并保持點亮，直到軟件將其關閉。LED由Tsi148中VSTAT寄存器的第14位（BDFAIL）控制。USR1用戶定義前面板紅色/黃色此指示燈由狀態指示器寄存器中相應寄存器位的S/W斷言點亮。有關詳細信息，請參閱《程序員指南》。
Front Panel The following switch, LEDs, and connectors are available on the MVME7100 front panel. Refer to Figure 3-1 for the location of each.Reset/Abort Switch The MVME7100 has a single push button switch to provide both the abort and reset functions. When the switch is depressed for less than 3 seconds, an abort interrupt is generated to the MC8641D PIC. If the switch is held for more than 3 seconds, a board hard reset is generated. If the MVME7100 is the VMEbus system controller, a VME SYSRESET is generated.LEDs The next table describes the LEDs on the front panel of the MVME7100. Refer to Figure 3- 1 on page 47 for LED locations.BFL Board Fail Front panel Red This indicator is illuminated during a hard reset and remains illuminated until software turns it off. The LED is controlled by bit 14 (BDFAIL) of the VSTAT register in the Tsi148. USR1 User Defined Front panel Red/Yellow This indicator is illuminated by S/W assertion of its corresponding register bits in the Status Indicator Register. See the Programmer's Guide for further detail.
