EMERSON KJ3206X1-BA1控制系統(tǒng)模塊
GNET1 SPEED TSEC1鏈路/速度前面板關閉黃色綠色無鏈路10/100 BASE-T操作1000 BASE-T操作GNET1 ACT TSEC1活動前面板關閉閃爍綠色無活動與帶寬利用率成正比的活動GNET2 SPEED TSEC2鏈路/速度后面板關閉黃色綠色無鏈路10/100BASE-T操作1000BASE-T操作GNDET2 ACT TSEC2活動前面板不閃爍綠色無活動與帶寬利用率成正比的活動連接器本節(jié)介紹了MVME7100上連接器的引腳分配和信號。下表列出了MVME7100基板上的標準連接器。有關連接器位置，請參閱第47頁的圖3-1。連接器的端號分配在以下部分中。一些連接器使用符合VMEbus、IEEE、PCI和ANSI/VITA規(guī)范的標準引腳分配。這些規(guī)范的鏈接
GNET1 SPEED TSEC1 Link / Speed Front panel Off Yellow Green No link 10/100 BASE-T operation 1000 BASE-T operation GNET1 ACT TSEC1Activity Front panel Off Blinking Green No activity Activity proportional to bandwidth utilization GNET2 SPEED TSEC2 Link / Speed Front panel Off Yellow Green No link 10/100 BASE-T operation 1000 BASE-T operation GNET2 ACT TSEC2 Activity Front panel Off Blinking Green No activity Activity proportional to bandwidth utilization Connectors This section describes the pin assignments and signals for the connectors on the MVME7100. The next table lists the standard connectors on the MVME7100 baseboard. Refer to Figure 3-1 on page 47 for connector locations. Pin assignments for the connectors are in the following sections. Some connectors use standard pin assignments in compliance with the VMEbus, IEEE, PCI, and ANSI/VITA specifications. Links to these specifications
