EMERSON 1C31113G04模擬輸入模塊
以太網連接器（GIGE/J2B、GIGE/J2A）MVME7100將兩個10/100/1000Mb/s全雙工以太網接口路由到VMEbus P2連接器。MVME7216E將這些從P2連接器路由到RTM面板上的RJ-45連接器。這些連接器包括用于速度和活動指示的集成LED。這些連接器的引腳分配如下：串行端口連接器（COM2–COM5/J1A-D）MVME7100將四個異步串行端口接口SP1–SP4路由到VMEbus P2連接器。MVME7216E將這些從P2連接器路由到RTM面板上的RJ-45連接器。PMC輸入/輸出模塊如果MVME7216 E上已經安裝了PMC輸入/輸入模塊（PIM），或者您正在安裝出廠的轉換模塊，請忽略此程序。對于PIM安裝，請執行以下步驟：1。在手腕上系上ESD腕帶。將ESD帶的另一端連接到機箱作為接地。在整個手術過程中，ESD帶必須固定在手腕和地面上。2.小心地將轉換模塊從包裝中取出，并將其平放在穩定的表面上。
Ethernet Connectors (GIGE/J2B, GIGE/J2A) The MVME7100 routes two 10/100/1000Mb/s full-duplex Ethernet interfaces to the VMEbus P2 connector. The MVME7216E routes these from the P2 connector to the RJ-45 connectors on RTM panel. These connectors include integrated LEDs for speed and activity indication. The pin assignments for these connectors are as follows:Serial Port Connectors (COM2–COM5/J1A-D) The MVME7100 routes four asynchronous serial port interfaces, SP1 – SP4, to the VMEbus P2 connector. The MVME7216E routes these from the P2 connector to the RJ-45 connectors on RTM panel.PMC Input/Output Module If a PMC Input/Output Module (PIM) has already been installed on the MVME7216E, or you are installing a transition module as it has been shipped from the factory, disregard this procedure Procedure For PIM installation, perform the following steps: 1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure. 2. Carefully remove the transition module from its packaging and lay it flat on a stable surface.
