EMERSON 1C31233G03事件差分順序數(shù)字輸入模塊
使用命令行接口與MOTLoad的交互通過單板計算機上的串行端口通過命令行接口執(zhí)行，該串行端口連接到終端或終端仿真器（例如，Windows的Hypercomm）。默認MOTLoad串行端口設置為：9600波特，8位，無奇偶校驗。MOTLoad命令行界面類似于UNIX命令行shell界面。通過在MOTLoad命令行提示符下輸入有效的MOTLoad命令（文本字符串）并按下回車鍵表示輸入結束，即可啟動命令。MOTLoad然后執(zhí)行指定的操作。MOTLoad命令行提示的示例如下所示。MOTLoad提示會根據所使用的產品（例如，MVME6100、MVME3100、MVME7100）而變化。示例：如果在MOTLoad命令行提示符下輸入了無效的MOTLoad命令，則MOTLoad將顯示一條消息，說明未找到該命令。示例：MVME7100>未找到mytest“mytest”MVME7100>
Using the Command Line Interface Interaction with MOTLoad is performed via a command line interface through a serial port on the single board computer, which is connected to a terminal or terminal emulator (for example, Window’s Hypercomm). The default MOTLoad serial port settings are: 9600 baud, 8 bits, no parity. The MOTLoad command line interface is similar to a UNIX command line shell interface. Commands are initiated by entering a valid MOTLoad command (a text string) at the MOTLoad command line prompt and pressing the carriage-return key to signify the end of input. MOTLoad then performs the specified action. An example of a MOTLoad command line prompt is shown below. The MOTLoad prompt changes according to what product it is used on (for example, MVME6100, MVME3100, MVME7100). Example:If an invalid MOTLoad command is entered at the MOTLoad command line prompt, MOTLoad displays a message that the command was not found. Example: MVME7100> mytest "mytest" not found MVME7100>
