BASLER DECS-100調節器
BASLER DECS-100活動控制器選擇要用作觸發器的I/O所屬的系統。信號顯示所有可用作觸發器的信號。觸發條件對于數字信號，設置當信號設置為真或假時是否觸發事件。對于僅適用于車站信號的模擬信號，事件應在以下任何條件下觸發：大于、大于/等于、小于、小于/等于、等于、不等于。添加打開一個對話框，用于將激活器信號添加到激活器信號窗格。移除移除選定的激活器信號。添加>打開一個對話框，用于將運算符符號添加到“連接”窗格。刪除刪除選定的運算符符號。延遲以秒為單位指定延遲。沖突類型設置要用作觸發器的沖突類型。Started=碰撞開始時觸發。Ended=沖突結束時觸發。BASLER DECS-100未遂事件開始=未遂事件開始時觸發。未遂事件結束=未遂事件結束時觸發。碰撞集選擇要用作觸發器的碰撞集。BASLER DECS-100
BASLER DECS-100調節器
Active Controller Select the system to which the I/O to use as a trigger belongs. Signals Displays all signals that can be used as triggers. Trigger Condition For digital signals, sets whether the event shall trigger when the signals are set as true or false. For analog signals, which are only available for station signals, the event shall trigger under any of the following conditions: Greater than, Greater/Equal, Less than, Less/Equal, Equal to, Not equal to.Add Opens a dialog box for adding an activator signal to the Activator Signals pane. Remove Removes a selected activator signal. Add > Opens a dialog box for adding an operator symbol to the Connections pane. Remove Removes a selected operator symbol. Delay (s) Specifies the delay in seconds.Collision Type Set the kind of collision to use as trigger. Started = Triggers when a collision starts. Ended = Triggers when a collision ends. Near miss started =Triggers when a near-miss starts. Near miss ended = Triggers when a near-miss ends. Collision set Select the collision set to use as trigger.
公司主營優勢
應用行業
