REXROTH DKC21.3-040-7-FW伺服驅動器
1.產 品 介 紹
品牌：REXROTH
型號說明：REXROTH DKC21.3-040-7-FW伺服驅動器
優勢：供應進口原裝正品，專業停產配件。
公司主營特點：主營產品各種模塊/卡件，控制器，觸摸屏，伺服驅動器。
2.產 品 詳 情 資 料：
REXROTH DKC21.3-040-7-FW伺服驅動器注意：為了使162Bug和終端之間的高波特率串行通信正常工作，終端必須進行某種形式的握手。如果所使用的終端沒有通過CTS線路進行硬件握手，那么它必須進行XON/XOFF握手。如果收到亂碼消息和丟失的字符，則應檢查終端以確保啟用了XON/XOFF握手。11.如果要將設備（如主機系統和/或串行打印機）連接到其他EIA-232-D端口連接器（MVME712x轉換模塊上標記為serial PORTS 2、3和4），請連接適當?shù)碾娎|并按照上述步驟3中的詳細說明配置端口。通電后，您可以通過編程MREXROTH DKC21.3-040-7-FW伺服驅動器串行通信控制器（SCC）或使用162Bug PF命令重新配置端口。
Note In order for high-baud rate serial communication between 162Bug and the terminal to work, the terminal must do some form of handshaking. REXROTH DKC21.3-040-7-FW伺服驅動器If the terminal being used does not do hardware handshaking via the CTS line, then it must do XON/XOFF handshaking. If you get garbled messages and missing characters, then you should check the terminal to make sure XON/XOFF handshaking is enabled. 11. If you want to connect devices (such as a host computer system and/or a serial printer) to the other EIA-232-D port connectors (marked SERIAL PORTS 2, 3, and 4 on the MVME712x transition module), connect the appropriate cables and configure the port(s) as detailed in Step 3 above. After power-up, you can reconfigure the port(s) by program-ming the REXROTH DKC21.3-040-7-FW伺服驅動器 Serial Communications Controller (SCC), or by using the 162Bug PF command.REXROTH DKC21.3-040-7-FW伺服驅動器
3.產 品 展 示
4.公 司 優 勢 主 營 產 品
5.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://qing-ting.cn
