NI PXI-5600變頻器
1.產 品 介 紹
品牌：NI
型號說明：NI PXI-5600變頻器
優勢：供應進口原裝正品，專業停產配件。
公司主營特點：主營產品各種模塊/卡件，控制器，觸摸屏，伺服驅動器。
2.產 品 詳 情 資 料：
將PROFIBUS DP電纜連接到基板上的PROFIBUS A或PROFIBUS B連接器之一。為了支持線路冗余，將另一根PROFIBUS DP電纜連接到另一個觸點。5.如果NI PXI-5600位于PROFIBUS DP電纜的末端，則打開總線終端。否則，保持總線終端關閉。以下適用于NI PXI-5600：6。如果CI854A安裝在冗余配置中，將PROFIBUS DP電纜連接到主模塊和備用模塊。如第117頁圖39所示。將位于線路末端的主模塊或備用模塊上的接口終端打開。PROFIBUS DP連接PROFIBUS DP電纜通過位于TP854上的9針D型母連接器連接。現場總線和推薦的認證現場總線設備和組件的安裝，請參閱現場總線文件和附錄C，推薦組件。PROFIBUS DP必須與屏蔽雙絞線連接。NI PXI-5600
Connect the PROFIBUS DP cable to one of the connectors PROFIBUS A or PROFIBUS B on the baseplate. For support of Line Redundancy connect a second PROFIBUS DP cable to the other contact. 5. If the NI PXI-5600 is at the end of the PROFIBUS DP cable, switch the bus termination ON. Otherwise leave the bus termination switched OFF. The following applies for CI854A: 6. If the NI PXI-5600 is installed in a redundant configuration connect the PROFIBUS DP cable to primary and backup module. Do it like described in Figure 39 on page 117. Switch the termination ON for the interface on primary or backup module that is at the end of the line.PROFIBUS DP Connection The PROFIBUS DP cable is connected via the 9-pin female D-type connector located on TP854.For installation of the fieldbus and recommended certified fieldbus devices and components, see fieldbus documentation and Appendix C, Recommended Components. The PROFIBUS DP must be connected with shielded twisted pair cables.
3.產 品 展 示
4.公 司 優 勢 主 營 產 品
5.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://qing-ting.cn
